Toyota Camry

 XV30 (2002–2006) Service Manual

Exterior/interior trim
Rear spoiler sub-assy

REPLACEMENT

HINT:

• The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
• A bolt without torque specification is a standard bolt.
• When replacing the moulding, heat the body and spoiler using a heat light.

Heating temperature:

NOTICE: Do not heat the body and spoiler excessively.

1. REMOVE LUGGAGE COMPARTMENT DOOR COVER

a. Remove the 15 clips and door cover.

2. REMOVE REAR SPOILER SUB−ASSY

1. Remove the 2 nuts.
2. Put protective tape onto the body.
3. Using a heat light, heat the spoiler.
4. Tie both piano wire ends to wooden blocks or similar objects.

1. Scrape the adhesive tape off by pulling the piano wire as shown in the illustration.
2. If reusing the rear spoiler, take care not to damage the rear spoiler.

NOTICE: Do not damage the body.

e. Disconnect the connector.

f. Remove the 2 clips and rear spoiler.

3. REMOVE CENTER STOP LAMP ASSY

4. INSTALL REAR SPOILER SUB−ASSY

1. Using a heat light.
2. Remove the protective tape from the body.
3. Wipe off the stains with cleaner.
4. Clean the rear spoiler (if reusing the spoiler).

1. Using a heat light, heat the spoiler.
2. Remove the adhesive tape from the rear spoiler.
3. Wipe off the stains with cleaner.
4. Install new adhesive tape to the rear spoiler as shown in the illustration.

5. Using a heat light, heat the body and spoiler.
6. Install the rear spoiler with 2 nuts.

Install rear spoiler sub-assy

Front bumper

Name plate

Front door belt moulding assy LH

Rear door belt moulding assy LH

Roof drip side finish moulding center LH

Outside moulding

Rocker panel moulding LH

Luggage compartment door garnish sub-assy outside

Front floor footrest

Front bumper

Roof headlining assy

Rear bumper

Rear spoiler sub-assy