Toyota Camry

 XV30 (2002–2006) Service Manual

Exterior/interior trim
Outside moulding

REPLACEMENT

HINT:

• The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
• Use the same procedures for the RH side and LH side.
• When replacing the moulding, heat the body and moulding using a heat light.

Heating temperature:

NOTICE: Do not heat the body and moulding excessively.

1. REMOVE OUTSIDE MOULDING

1.  Using a heat light heat the moulding.
2. Tie both piano wire ends to wooden block or similar object.
3. Scrape the double−sided tape off by pulling the piano wire as shown in the illustration.

NOTICE:

• If reusing the moulding, take care not to damage the moulding.

• Do not damage the body.

Remove outside moulding

2. INSTALL OUTSIDE MOULDING

1. Using a heat light, heat the body.
2. Remove the protective tape from the body.
3. Wipe off the stains with cleaner.
4. Clean the moulding (if reusing the moulding).

1. Using a heat light, heat the moulding.
2. Remove the double−sided tape from the moulding.
3. Wipe off the stains with cleaner.
4. Apply new bouble−sided tape to the moulding as shown in the illustration.

5.  Using a heat light, heat the body and moulding.
6. Remove the peeling paper from the face of the moulding and attach the moulding securely to the vehicle body.

NOTICE: Be careful that dirt or foreign objects do not stick to adhesive part when removeing the peeling paper.

g. Push the moulding to the body.

NOTICE: Do not apply excessive force onto the moulding. Instead, apply steady pressure with your thumbs.

Front bumper

Name plate

Front door belt moulding assy LH

Rear door belt moulding assy LH

Roof drip side finish moulding center LH

Outside moulding

Rocker panel moulding LH

Luggage compartment door garnish sub-assy outside

Front floor footrest

Front bumper

Roof headlining assy

Rear bumper

Rear spoiler sub-assy