REPLACEMENT
HINT:
COMPONENTS
Replace the RH side by the same procedures with the LH side.
REMOVE REAR WHEEL
DISCONNECT REAR DISC BRAKE CALIPER ASSY LH (DISC REAR BRAKE TYPE)
a. Remove the bolt and disconnect the rear flexible hose.
Remove the 2 bolts and rear disc brake caliper assy LH.
Support the brake caliper assy LH securely.
REMOVE REAR DISC (DISC REAR BRAKE TYPE)
REMOVE REAR BRAKE DRUM SUB−ASSY (DRUM REAR BRAKE TYPE)
DISCONNECT SKID CONTROL WIRE (W/ ABS)
REMOVE REAR AXLE HUB & BEARING ASSY LH
a. Remove the 4 bolts and rear axle hub LH & bearing assy LH.
REMOVE SKID CONTROL (W/ ABS)
INSTALL SKID CONTROL (W/ ABS)
INSTALL REAR AXLE HUB & BEARING ASSY LH
a. Install the rear axle hub LH & bearing assy LH with the 4 bolts.
Torque: 80 N·m (816 kgf·cm, 59 ft·lbf)
Install rear axle hub & bearing assy LH
INSTALL SKID CONTROL WIRE (W/ ABS)
INSPECT BEARING BACKLASH
a. Set a dial indicator near the center of the axle hub and check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 in.)
If the backlash exceeds the maximum, replace the axle hub assembly.
Inspect bearing backlash
12. INSPECT AXLE HUB DEVIATION
a. Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 in.)
If the backlash exceeds the maximum, replace the axle hub assembly.
I
nspect axle hub deviation
INSTALL REAR DISC (DISC REAR BRAKE TYPE)
INSTALL REAR DISC BRAKE CALIPER ASSY LH (DISC REAR BRAKE TYPE)
a. Install the rear disc brake caliper assy LH with the 2 bolts.
Torque: 62 N·m (630 kgf·cm, 46 ft·lbf)
b) Install the rear flexible hose with the bolt.
Torque: 19 N·m (192 kgf·cm, 14 ft·lbf)
INSTALL REAR BRAKE DRUM SUB−ASSY (DRUM REAR BRAKE TYPE)
INSTALL REAR WHEEL Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
INSPECT AND ADJUST REAR WHEEL ALIGNMENT
CHECK ABS SPEED SIGNAL (W/ ABS)
ABS WITH EBD SYSTEM (BOSCH MADE)
ABS WITH EBD SYSTEM (DENSO MADE)
ABS WITH EBD & BA & TRAC & VSC SYSTEM