Toyota Camry

 XV30 (2002–2006) Service Manual

Supplemental restraint system
Occupant classification ecu (From July, 2003)

COMPONENTS

REPLACEMENT

HINT: Installation is in the reverse order of removal.

1. PRECAUTION

2. DISCONNECT BATTERY NEGATIVE TERMINAL

3. REMOVE FRONT RH SEAT ASSY

4. REMOVE OCCUPANT CLASSIFICATION ECU

1. Disconnect the connectors from the occupant classification ECU.

2. Using a screwdriver, remove the occupant classification ECU.

Remove occupant classification ecu

5. INSTALL OCCUPANT CLASSIFICATION ECU

1. Check that the ignition switch is off.

2. Check that the battery negative (−) terminal is disconnected.

CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.

1. Install the occupant classification ECU.

2. Connect the connectors to the occupant classification ECU.

NOTICE:

• If the occupant classification ECU has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the occupant classification ECU with a new one.

• When installing the occupant classification ECU, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.

6. INSTALL FRONT RH SEAT ASSY

7. OCCUPANT CLASSIFICATION ECU INITIALIZATION

8. INSPECT SRS WARNING LIGHT

Horn button assy

Spiral cable sub-assy

Front passenger airbag assy (From July, 2003)

Curtain shield air bag assy LH

Front seat airbag assy RH

Air bag sensor assy center

Air bag front RH sensor

Air bag sensor front LH

Air bag sensor front LH

Air bag sensor front LH

Side air bag sensor assy RH

Air bag sensor rear LH

Seat position air bag sensor (From July, 2003)

Occupant classification ecu (From July, 2003)