Toyota Camry

 XV30 (2002–2006) Service Manual

Brake
Speed front LH

REPLACEMENT

HINT: Replace the RH side by the same procedures with LH side.

1. REMOVE FRONT WHEEL

2. REMOVE FRONT FENDER LINER LH

3. REMOVE SPEED FRONT LH

a Disconnect the speed connector and clamp.

b. Remove the 2 clamp bolts holding the harness and clamp from the body and shock absorber.

c. Remove the bolt and speed FR LH.

NOTICE: Do not stick and foreign matter on the tip.

4. INSTALL SPEED FRONT LH

a. Install the speed FR LH with the bolt.

Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)

NOTICE: Make sure the tip is clean.

2. Install the harness clamps with the 2 bolts ”A” and ”B” to the body and shock absorber.

   Torque:
   Bolt A: 5.0 N·m (51 kgf·cm, 44 in.·lbf) Bolt B: 18.8 N·m (192 kgf·cm, 14 ft·lbf)

3. Connect the clamp to the knuckle.

d. Connect the speed connector and clamp.

5. INSTALL FRONT FENDER LINER LH

6. INSTALL FRONT WHEEL Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)

7. CHECK ABS SPEED SIGNAL

Brake system

Brake pedal support assy

Accelerator & brake pedal assy

Brake system

Brake master cylinder sub-assy

Brake booster assy

Front brake

Brake fluid

Rear disc brake

Rear drum brake

Brake actuator assy (W/O VSC)

Brake actuator assy (W/ VSC)

Speed front LH

Skid control

Yawrate

Steering

Adjustable pedal switch

Adjustable pedal relay

Brake pedal support assy